F=ma FMA1046A Network Driver

F=ma FMA1046A Driver. *******************************************************************

* F=ma Networks *

* USB 10/100 ETHERNET ADAPTER *

* V1.12.00 *

* Copyright (C) 2000 F=ma Networks *

* All Rights Reserved. *

*******************************************************************

IS USB CORRECTLY INSTALLED?

if you connect to the USB Ethernet Adapter and nothing happens, you may have a

problem with the USB setup. To determine if USB is correctly installed, proceed as follows:

1. Right-click on 'My Computer'

2. Click 'Properties'

3. Select the 'Device Manager' tab

4. If 'Universal serial bus controller' is not listed:

A. USB is not installed on your machine

B. Contact your system manufacturer for instructions on installing USB support

5. If 'Universal serial bus controller' is listed:

A. Click the '+' sign next to the title to expand that section

B. Highlight 'USB Root Hub'

C. Click 'Properties'

D. Verify that the USB Root Hub is working properly

*******************************************************************

*******************************************************************

The driver (EN1046.SYS) contained in the DISK is for

the following F=ma USB EN1046 10/100 Ethernet adapter:

F=ma Networks' EN1046 USB 10/100 Ethernet Adapter

The driver (EN1046.SYS) conforms to the Network Driver Interface

Specification (NDIS) 5.0, and is used with Microsoft Windows 98

or Windows 2000 (NT 5.0).

Contents:

---------

(A) Installing the NDIS5 Miniport driver on Microsoft Windows 98 (2000)

=================================================================

1. Plug F=ma's EN1046 adapter into one of USB Port.

2. Turn the power ON, then boot from Windows 98.

3. When Windows 98 prompts with "F=ma Network Ethernet Adapter" in

"New Hardware Found" dialog box, click the "Next" button.

4. Select "Search for the best driver for your device (Recommended)"

form the "Add New Hardware Wizard" dialog box, then click the

"Next" button.

5. Insert the F=ma EN1046 Driver Diskette in your floppy drive.

6. Select "Specify a location" and type Path "A:\" in the

"Add New Hardware Wizard" dialog box, then click the "Next" button.

7. Click the "Next" button in the "Add New Hardware Wizard" dialog box.

8. Windows 98 will prompt with "F=ma Network Ethernet Adapter"

in the "Add New Hardware Wizard" dialog box.

9. Click the "Next" button in the "Add New Hardware Wizard" dialog box, then

Windows 98 will copy the driver (EN1046.SYS) from A:\

to the C:\WINDOWS\SYSTEM directory and the EN1046.INF file from A:\

to the C:\WINDOWS\INF directory.

10. When Windows prompts with "F=ma Network Ethernet Adapter"

in the "Add New Hardware Wizard" dialog box, click the "Finsh" button.

11. Remove the F=ma EN1046 Driver Diskette from your floppy drive.

12. Restart your computer to initialize the network function.

NOTICE!! C:\WINDOWS is the directory where your Windows 98

O.S. is located.

Trademarks:

Microsoft Windows 98 is a trademark of Microsoft Corporation.